Weed Eater 530163441 Instrukcja Obsługi Pobierz pdf (Strona 6)

Always release the throttle trigger and altow

the engine to return to idle speed when not

cutting.

To stop engine:

• Release the throttle trigger,

• Move the ON/OFF switch to the OFF posi-

tion,

TRIMMER LINE ADVANCE

The trimmer tine will advance approximately 2

in. (5 cm) each time the bottom of the trimmer

head is tapped on the ground with the engine

running at full throttle,

The most efficient line length is the maximum

tength allowed by the line limiter.Atways keep

the shieM in place when the tool is being oper-

ated,

To advance Hne:

• Operate the engine at full throttle,

• Hold the trimmer head parallel to and above

the grassy area.

• Tap the bottom of the trimmer head lightly

on the ground one time, Approximately 2 in.

(5 cm) of tine will be advanced with each

tap.

Always tap the trimmer head on a grassy

area. Tapping on surfaces such as concrete

or asphalt can cause excessive wear to the

trimmer head.

If the line is worn down to 2 inches (5 cm) or

tess, more than one tap will be required to ob-

tain the most efficient line length.

_l_ WARNING: use only 0.080" (2 mm)

diameter line. Other sizes of line will not ad-

vance properly and can cause serious injury.

Do not use other materials such as wire,

string, rope, etc. Wire can break off during

cutting and become a dangerous missile that

can cause serious injury.

CUTTING METHODS

_WARNING: use minimum speed

and do not crowd the tine when cutting around

hard objects (rock, gravel, fence posts, etc.),

which can damage thetrimmer head, become

entangled in the line, or be thrown causing a

serious hazard,

• The tip of the line does the cutting, You will

achieve the best performance and

minimum line wear by not crowding the line

into the cutting area, The right and wrong

ways are shown below.

]'Ep o _-e Line

Right |

• The line will easily remove grass and

weeds from around walls, fences, trees and

flower beds, but it also can cut the tender

bark of trees or shrubs and scar fences,

• For trimming or scalping, use less than full

throttle to increase line life and decrease

head wear, especially:

• During light duty cutting.

• Near objects around which the line can

wrap such as small posts, trees or fence

wire,

• Formowingorsweeping, usefullthrotflefor

a good clean job.

TRIMMING - Hold the bottom of the trimmer

head about 3 in, (8 cm) above the ground and

at an angle. Allow only the tip of the line to

make contact, Do not force trimmer line into

work area.

Trimming

3 in, (8 cm)

Above Ground

SCALPING - The scalping technique re-

moves unwanted vegetation. Hold the bottom

of the trimmer head about 3 in. (8 cm) above

the ground and at an angle. Allow the tip of the

line to strike the ground around trees, posts,

monuments, etc. This technique increases

line wear.

Scalping

MOWING - Your trimmer is ideal for mowing

in places conventional lawn mowers cannot

reach, in the mowing position, keep the line

parallel to the ground, Avoid pressing the

head into the ground as this can scalp the

ground and damage the tool.

Mowing

1 2 3 4 5 6 7 8 9 10 11 ... 34 35

Komentarze do niniejszej Instrukcji

Brak uwag